X3-KIT
Installation and Operation Manual
PG 31/40
REV: BETA (4/25/2019)
8.9.4.
Remove three (3) M12 OE bolts that hold front sway bar and remove small T30 bolt holding Brake Line
next to firewall, as shown below. Use care removing fasteners, as they will be re-used.
NOTE: Removal of both front wheels will facilitate installation; however, if front suspension is fully
extended (i.e., vehicle supported in center with no weight on suspension), the coil springs will be closer
to Horn Trumpets, which increases difficulty installing Air Horn.
Figure 26
–
Sway Bar Bolts to remove and Brake Line Bolt (looking from above)
8.9.5.
Cut supplied large corrugated wire loom (E4)
into two 6” long
pieces and fit over Coolant Tubes, as shown
in figure above. Re-adjust loom position as necessary, to provide protection from Bracket touching.
8.9.6.
Install X3-301 by pulling upwards on Brake Lines and sliding Bracket underneath, but above Coolant
Tubes, as shown below. Use supplied Zip-ties and gently secure Brake Lines, Coolant Tubing, and Wiring
to Bracket using small square slots. Zip-ties will be tightened later.
Re-install and torque T30 Bolt
.
NOTE: On vehicles equ
ipped with “Smart
-
Lok” ®
locking front differential, disconnect vacuum/vent line
to differential, if necessary and route above Bracket, then re-connect to front differential.
Figure 27
–
Air Horn Bracket Installed below Brake Lines
1
2
3
FR
ONT
INSERT
Use extra U-
Trim below
wires
Zip-Tie
OE T30
OE T30
OE M12
Cut E4 into two 6”
long pieces; place
over Coolant Tubes
