Kleinn Air Horns X3-KIT, Руководство по установке

Страница: 30 / 40

X3-KIT
Installation and Operation Manual
Go to Table of Contents PG 30/40 REV: BETA (4/25/2019)
8.9. Air Horn - Installation
8.9.1. Disassemble Trumpets from Air Horn Driver (item 3 in below picture), by grasping Trumpet throats with
hand and twisting counter-clockwise; it may be necessary to clamp Air Horn Driver. Air Horn should be
separated into three components, as shown below.
Figure 23 – Disassembly of Air Horn by Separating Trumpets
8.9.2. Gather X3-301 Horn Bracket, hardware H 5 (2), and a 4” long piece of masking tape, or similar and
temporarily tape carriage bolts to bottom of Bracket, as shown below; threads should be sticking up.
NOTE: This step is necessary, as space constraints near Sway Bar make it difficult to insert bolts with
Bracket in place. Apply tape long enough that it can be easily removed after installation.
Figure 24 – Carriage Bolts temporarily taped in place on Horn Bracket
8.9.3. Gather X3-302 and Rubber U-Trim ( hardware H18), cut trim and install into holes, as shown below.
Figure 25 – X3-302 with Rubber U-Trim installed, exploded view
TAPE
H5 (2)
X3-301
5.5” LONG
4.5” LONG
X3-302