Kleinn Air Horns X3-KIT, Руководство по установке

Страница: 25 / 40

X3-KIT
Installation and Operation Manual
Go to Table of Contents PG 25/40 REV: BETA (4/25/2019)
8.6. Air Tank - Installation
8.6.1. Before starting, ensure at least 6 FT. of supplied ¼” Air Tubing is connected to Air Tank front port , to
allow easily routing across rear firewall/chassis and connecting to Air Compressor.
8.6.2. Place Air Tank onto Brackets to determine if front Bracket needs to be adjusted (i.e., made level); make
any hand adjustments necessary, remove Air Tank, then
final torque front Bracket , per figure 10 above.
8.6.3. Install Air Tank onto Brackets, using hardware #H5, H7, H9 & H10, as shown below.
NOT E: Position Air Tank and Brackets, as necessary to maintain a minimum ¼” clearance between
suspension spring and Bracket. It is ok if Air Tank contacts inner plastic fender, or back of Brackets.
Figure 14 – Installing Air Tank onto Brackets, Exploded View
8.6.4. Once Air Tank is properly positioned, final torque all Air Tank bolts and then rear Bracket bolts , per
figure 11 above.
8.6.5. Remainder of Air Tank installation will be completed during electrical wiring and Quick Connect routing.
FRONT
H10 (4)
H5 (4)
H9 (4)
H7 (4)