TJXTREME
Installation and Operation Manual
PG 22/36
REV: A (5/8/2020)
8.5.
Connect Air Compressor Leader Hose
8.5.1.
Apply two small drops of
to male pipe thread on end of Compressor Leader Hose.
8.5.2.
to end of Leader Hose and hand tighten, then use wrench to further tighten 1/4-1/2
Turn.
CAUTION:
do NOT over tighten; over tightening may damage one-way ball valve
. Read all instructions
accompanying Air Compressor thoroughly.
8.5.3.
Cut at least a 2 ft section of 1/4”
and firmly attach to Compression
8.5.4.
If desired at this time, secure Leader Hose and Fitting to Bracket using supplied Zip Ties, as shown below.
Figure 9
–
Air Tubing Connections (View Showing Complete Assembly, as if under vehicle)
8.6.
Connect Air Horn Drivers with Air Tubing
8.6.1.
, and T-Fitting included (*) in Air Horn package, connect Drivers, as shown in
figure above. Cut as needed and apply rubber trim
to Bracket where Tubing touches.
8.6.2.
Cut at least a 3 ft section of 1/4”
and connect remaining side of T-Fitting, which will go to
Air Tank later on.
8.6.3.
If desired at this time, secure Air Tubing to Bracket using supplied Zip Ties, as shown above.
End of Section
LEADER HOSE
LEADER END
F9
ZIP TIES
F8
*T-FITTING
H15
F9
H14
