Klein Marine Systems, Inc. HydroChart 5000, Руководство по эксплуатации и обслуживанию

Страница: 47 / 82

Topside System Controls and Indicators
3-11
3.8 Topside System Controls and Indicators
The TPU and the SonarPro Workstation include controls and indicators on the
front panels. The SonarPro Workstation also has its power switch on the back
panel.
3.8.1 TPU Controls and Indicators
All of the TPU controls and indicators are on the TPU front panel which is shown
in Figure 3-6.
The TPU controls and indicators are the following:
POWER switch:
Rocker switch/circuit breaker that turns the TPU on
or off and provides AC input current protection.
Should the breaker trip, the switch/circuit breaker
will switch to the OFF position. To reset it, switch it
to the ON position.
POWER:
Green LED that is on when the TPU is powered.
SYS READY:
Green LED that will flash while the TPU and the
Sonar Head Unit are powering up and then remain
on when the TPU is ready to link with SonarPro on
the SonarPro Workstation.
T/F POWER:
Blue LED that is on when power is being output to
the Sonar Head Unit.
TOWFISH AWAKE:
Green LED that is on when the Sonar Head Unit is
powered and is acquiring data.
TOWFISH DOWNLINK:
Green LED that is on when commands are being
transfered from the TPU to the Sonar Head Unit.
TOWFISH UPLINK:
Green LED that is on when data are being transfered
from the Sonar Head Unit to the TPU.
STATUS TRIGGER:
Yellow LED that flashes when the sonar on the
Sonar Head Unit transmits.
STATUS RESPONDER:
Yellow LED that flashes when a responder trigger is
sent to the Sonar Head Unit.
STATUS ERROR:
Red LED that flashes if system errors are detected.