KKT chillers vBoxX 10, Инструкция по эксплуатации

Страница: 43 / 82

43 / 82 83000602.Ke
6.2.8. Surface and Foundation
The surface on which the machine is installed must be flat and horizontal. All the machine's feet
must have uniform contact with the floor or ground. Ensure that the floor/subsurface has sufficient
load-bearing capacity. The installation instructions (
Appendix II ) recommend a continuous concrete
foundation with the given minimum size. See .... The gross weight of your machine is given in the
technical specifications (
Table 3 ). In the case of chillers equipped with a tank, the net weight in
operation increases by the tank capacity. The sum is the gross weight.
If it is not possible to lay a foundation the machine can also be installed on a baseframe made of
steel sections. Here too, ensure that all the unit feet have uniform contact with the baseframe.
6.2.9. Stability
The machine usually stands firmly with its baseplate on the ground or floor. It is not necessary to
fix the machine onto the floor. However, if this is not possible due to the ambient conditions, the
machine can be equipped with the optionally available levelling feet (
3.25 Vario Foot ). The levelling
feet provide very good resistance to slipping. If this is not sufficient for your application the machine
can also be bolted onto the floor. Holes for this are provided in the machine baseplate. The system
designer is responsible for choosing suitable fixing elements.
6.2.10. Levelling
If it is necessary to level the chiller on the ground, this can be done using the optionally available
levelling feet.
6.2.11. Vibration isolation
If it is necessary to isolate the chiller from the ground, this can be done using the optionally available
levelling feet. The levelling feet are equipped with vibration isolating elastomers.