Kiwi Technics Kiwi-30, Руководство пользователя

Страница: 30 / 66

30
Global Parameters Edit
Midi In Channel 511 Midi In Channel Range is 1-16 or 17=Omni
Midi Out Channel 512 Midi Out Channel Range is 1-16
Seq Midi Out
Channel 513 Seq Midi Out Channel Range is 1-16
Enable MidiCC 514 Enable MidiCC Options are
Off – No Midi CC Send or Recv
1 – Input Only
2 – Output Only
3 – Both Input and Output
Enable Midi Sysex 515 Enable Midi Sysex Options are
Off – No Midi Sysex
On – Sysex Receive Enabled
Enable Program
Change 516 Enable Program Change Options are
Off – No Program Change
On – Midi Program Change Enabled
Midi Soft Through 517 Midi Soft Through Options are
Off – Stop All
1 – Pass All
2 – Pass Only nonCC
3 – Stop Only used MidiCC
Midi Clock Gen 518 Midi Clock Generation Options are Off, On
The Kiwi-30 will output a midi clock
which is set by the internal clock rate
when this parameter is set On
Master Clock Source 521 Master Clock Source Options are Internal or Midi.
Note – If midi is selected and there is no
midi clock present then Arp, Seq or
Sync'd LFOs will not run
Master Clock Rate 522 Master Clock Rate Range is 0-127 which is 5-299 BPM
Master Fine Tune 523 Master Fine Tune Range is 0-127
64=A440
Clock Display 524 Clock Display Options are
Off – No clock pulse is displayed on the
front panel
On – Master Clock will pulse the CLOCK
LED on the front panel
While in ARP or SEQ modes the clock
light will show the ARP & SEQ divided
rates
www.kiwitechnics.com Kiwi-30 Upgrade User Manual v121