Kiwi Technics Kiwi-30, Руководство пользователя

Страница: 43 / 66

43
2) The Display Board
Step 1) Remove the front panel. This involves removing the two slider knobs and the 3
screws on the top and the three screws on the bottom of the front panel. Note –
the top screws and the bottoms screws holding the panel on are different
and should not be mixed. The top screws need to be put back into the top
when refitting the panel.
Step 2) Remove the Cart hardware. Remove the two screws holding the circuit board to
the back of the plastic Cart socket. Remove the two long screws holding on
circuit board to the rear of the cart socket and keep these to one side as they will
be used to mount the LCD. Remove the two screws on the front of the plastic Cart
unit (marked with yellow arrows) and remove the cart plastic and board assemblies from the MKS-30.
Step 3) Remove the Midi light board. This is held on by a single screw. Unsolder the red and green wires from this board marked 'A' and 'K'.
Step 4) Desolder and remove one of the two wire looms from the Cart board. These are both the same and either one will do. Solder this into the Kiwi-30 Display
board taking note of the orientation. The wire in the number 1 position (this is black in our unit) must be fitted as is shown in the photo. If this is put in
backward it will damage the display unit. Make sure that the pins of the plug do not touch the metal case of the display unit.
Step 5) The wires going to the front panel need to be moved to make room for the display board. To do this unscrew the two PG200 socket screws so the PG200
socket can be move out from the synth a few centimeters. The wires going to the plugs CN6, CN7 & CN8 need to be moved and put through the PG-200
hole as shown in the photo. These can then be plugged back into CN6, CN7 & CN8 and replace the PG-200 socket using the same screws.
www.kiwitechnics.com Kiwi-30 Upgrade User Manual v121