KitchenAid KGCV465MMT, Техническое образование, Страница: 27 / 32

5-1
COMPONENT TESTING
Before testing any of the components, perform
the following checks:
• The most common cause for control failure is
corrosion on connectors. Therefore, discon-
necting and reconnecting wires will be nec-
essary throughout test procedures.
• All tests/checks should be made with a VOM
or DVM having a sensitivity of 20,000 ohms-
per-volt DC, or greater.
• Check all connections before replacing com-
ponents, looking for broken or loose wires,
failed terminals, or wires not pressed into
connectors far enough.
• Resistance checks must be made with power
cord unplugged from outlet, and with wiring
harness or connectors disconnected.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Refer to pages 4-6 and 4-8 for the procedure
for servicing the ignition switches.
NOTE: The four standard ignition switches will
be serviced as a complete assembly. If a switch
is defective, the complete assembly must be
replaced. The TripleTier

Crown burner igni-
tion switch is serviced separately.
1. Turn off gas supply and disconnect power
to the cooktop.
2. Set the ohmmeter to the R x 1 scale.
3. Locate the black and white ignition switch
connectors, (one is connected to the spark
module, and the other is connected to the
main wire harness), and disconnect them.
TripleTier

Crown
Burner Ignition
Switch
Standard Burner
Ignition Switch
4. Turn all of the switches to the Off position.
5. Touch the ohmmeter test leads to the
connectors on the black and white switch
wires. The meter should indicate an open
circuit (infinite
∞
).
6. Separately turn each of the five controls to
the “lite” position. The meter should indi-
cate a closed circuit (0 ohms) for each
switch.
Black Wire Connector
White Wire Connector
IGNITION SWITCHES