888-525-6745
5
AFTER SALES SUPPORT
7-cup cordless water kettle
Instructions
Safety cut-out
Cleaning and maintenance
Filter
Descaling
Remove the power base from inside the kettle if stored there.
Always make sure that the kettle is separate from the power base before filling it, or before any
operation.
Raise the lid by pressing on the trigger in the handle, and fill the tank with fresh water, paying
attention not to fill under the minimum mark and above the maximum mark indicated on the
water window (corresponding to 1.7L – approximately 7 cups of water).
Release the trigger to close the lid and make sure it closes correctly.
Put the kettle onto the power base, plug the power cord into the wall socket and switch the kettle
on. The pilot light of the switch will come on, indicating that the appliance is operating. If it does
not come on, check if the kettle is correctly positioned on the base and check if the base is
plugged in.
The cordless water kettle will switch off automatically when the water has boiled. However, you
can stop the appliance at any time by putting the switch in off position.
For instant re-boiling, wait until water has cooled down and switch on the appliance again.
•
•
•
•
•
•
•
This cordless water kettle is protected with an automatic safety device if accidentally switched on
without water.
Note: Please bear in mind that only the internal thermostat is switched off in case of overheat,
whereas the switch stays in the ON-position.
In this happens, switch off the appliance by putting the switch in the OFF position and wait
about 10 minutes for the heating element to cool. Then pour in sufficient cold water to cover the
heating element. This will reset the safety device.
The kettle may then be used as normal.
•
•
•
Before attempting any cleaning operation, make sure the appliance is unplugged from the power
socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly. Never
use abrasive products.
On no account must the cordless water kettle or its power base be immersed in water.
Any other servicing should be performed by an authorized service representative!
•
•
•
•
Your appliance is provided with a mesh filter. This filter is factory pre-installed before the spout.
The filter is placed in front of the spout. Filter should be rinsed clean regularly. For this, slide the
filter out, rinse under water, and slide it back in into position once clean.
•
•
To remove lime scale from the cordless water kettle, please use products made especially available
for this purpose. Make sure to use a type recommended for plastic kettles or coffee makers. Do not
use vinegar to de-calcify the kettle.
