Kistler-Morse STXplus, Инструкция по установке и эксплуатации

Страница: 27 / 76

APPENDIX B: KISTLER-MORSE
®
PROTOCOL SERIAL COMMANDS
‘o’ Command — Default Calibration Constants Only
This command is sent by the master to request the STXplus to default only the calibration
constants. For this example, the master requests the STXplus at address 01 to default its
calibration constants.
Request from Master Response from STXplus
>aaossr Ar Format
>01oD0r Ar Example
‘i’ Command — Default STXplus
This command is sent by the master to request the STXplus to reset to default conditions. For
this example, the master requests the STXplus at address 01 to default itself.
Request from Master Response from STXplus
>aaissr Ar Format
>01iCAr Ar Example
‘H’ Command — Perform HI Span Calibration
This command is sent by the master to request the STXplus calibrate its current input A/D to
correspond with the engineering units value that was sent by the master by adjusting it’s HI Span
calibration points. The range of this value can be ±2,147,483,647. The response from the
STXplus will be a single digit status where 0 for successful, 1 for successful but there was a less
than desirable difference between the HI Span and LO Span values, or 2 for successful but the HI
Span value was less than the LO Span value. For this example, the master sends the STXplus at
address 01 a value of 14356.2 assuming that the format is set to 3(X.X).
Request from Master Response from STXplus
>aaH±fffffffssr Ar Format
>01H14356.20Cr A030r Example
‘L’ Command — Perform LO Span Calibration
This command is sent by the master to request the STXplus calibrate its current input A/D to
correspond with the engineering units value that was sent by the master by adjusting it’s LO
Span calibration points. The range of this value can be ±2,147,483,647. The response from the
STXplus will be a single digit status where 0 for successful, 1 for successful but there was a less
than desirable difference between the HI Span and LO Span values, or 2 for successful but the HI
Span value was less than the LO Span value. For this example, the master sends the STXplus at
address 01 a value of -96700. assuming that the format is set to 0(X00.) and the difference
between the HI Span and the LO Span values was less than desirable.
Request from Master Response from STXplus
>aaL±fffffffssr Ar Format
>01L-96700.0Er A131r Example
B-8