KisanKraft
TM
INTERCULTIVATOR
KK-IC-8626
: www.kisankraft.com
: +91.80. 22178200
Page 15 of 48
STARTING INSTRUCTIONS
Starting Your Tiller/Cultivator for the First Time Cold Engine)
1. Fill the fuel tank with the proper oil/gasoline mixture. (See previous section.)
2. Hand tighten the gasoline cap just until its snug.
3. Move run/stop lever into the “run”
position.
4. Slide the choke lever back to close
the engine choke
5. Locate the purge bulb on the upper
right of the engine, in front of the
fuel tank. It sends fuel into the
carburetor, for easy starting. Press
the purge bulb until you see fuel
flow through t e clear fuel return
line.
Since you’re starting “cold,” you
may need to press six to eight
times. As soon as fuel starts flowing
through the clear fuel line, stop
pressing!
6. Don
’
t pull the throttle trigger during the starting of the engine.
7. Pull the starter cord slowly until resistance is felt. Then give the recoil starter
cord a few short, brisk pulls until the engine fires. During cold starting, you
may need to pull at least three or four times before the engine fires.
NOTE
: When the choke is closed, never pull the cord more than four or five
times. Over pulling may cause flooding. Also, bear in mind that, when the
engine fires, it only coughs or sputters, and will not run on choke.
