KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-410P
This warranty is null & void, if you fail to register the warranty with KisanKraft
by sending the KisanKraft Copy with dealer’s stamp
. KisanKraft Limited
: +91.80. 6835 7800
Page 18 of 52
IMPORTANT POINTS IN ENGINE OPERATION
1.
Break-In Of New Engine
:
If your engine has not yet break-in, improper usage will shorten the life of engine. The
initial 20 hrs. is the break-in-period. The operator must obey the following items
2.
Running In For 5mins After First Start:
Run with low speed and low load before the engine gets hot. Avoid running with high
speed and full load, or low speed and no load.
3.
Avoid Running with Overload:
During break-in period, the engine can't run with full load, but can run with 3000rpm and
50% load.
4.
Change Engine Oil Regularly:
After working for 20hrs, change the oil when engine is still warm, otherwise it will be
difficult to drain the residual oil from the engine.
Oil Bath Type Air Filter:
1.
Check the oil level before operating.
2.
Fill oil up to upper limit. If oil is dirty, change it. Please use diesel to clean oil bath
element frequently, then dip the element in the oil and squeeze out extra.
Running
WARNING
•
Be sure to operate the engine in a good, ventilated place in order to avoid exhaust
poisoning.
•
Avoid letting hands, body & clothes entangle in output shaft, belt pulley, V-type belt
pulley and other moving parts, so as to prevent from getting injured.
•
Stop the engine first and then maintain the movable parts and other parts around it.
Make sure there are no tools and sundries in the body of the engine before
operating.
Run engine for 5mins to warm up
Note
:
•
The muffler becomes very hot during and immediately after operation. Please don't
touch it.
•
The air filter will inhale the air around itself when the engine works. Don't let the
hands, body and clothes approach the air filter to avoid injury.
After the engine becomes warm, put the speed lever on necessary position to run the
engine.
Note
•
Be sure to use the speed lever to adjust the speed of engine.
•
Do not loosen the speed limit screw and fuel control screw; otherwise, the speed
and output of the engine will be abnormal.
Running
a)
If the engine gives out black smoke continuously, it is because the engine is
overloaded. The belt pulley of the engine or that of the powered equipment must be
adjusted.
b)
Pay attention to the following points when the engine is running:
