KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-406D
KK-IC-406D (Electric Start)
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp.
: +91.80. 6835 7800
Page 17 of 56
Before Operating an Engine
Break-in of new engine:
•
Refer to the Engine
’s instruction manual for the breaking-in of the diesel engine
•
As for a new or overhauled Inter-cultivator, it should be working for 1 hour under no
load or 5 hours under light load, then drain all the lubricant from the gearbox and
crankcase of the diesel engine, refill appropriate fix of clean diesel, and clean them
at a slow speed for 3-5 minutes, then drain the diesel off. Refill engine oil into them
according to instructions to enter four hours breaking-in, then the machine can work.
•
If your engine is not breaking in yet, improper usage will shorten the life of engine.
The initial 20 hrs. is the break-in-period. The operator must obey the following rules:
Running in for 5 minutes after first start:
Running with low speed and low load before the
engine gets hot. Avoid running with high speed and full load, or low speed and no load.
Avoid running with overload:
During break-in period, the engine can't run with full load, but
can run with 3000rpm and 50% load.
Change engine oil regularly:
After working for 20hrs, change the oil when engine is still warm,
otherwise it will be difficult to drain the residual oil in the engine.
Oil Bath Type Air Filter
:
•
Check the oil level before operating.
•
Fill oil up to upper limit. If oil is dirty, change it. Please use diesel to clean oil bath
element frequently, then dip the element in the oil and squeeze out extra.
Starting the Engine
Note
: The shift bar must be in the neutral position
1.
Start the diesel engine according to the procedures stipulated in the instruction
manual for the diesel engine.
2.
The diesel engine should run at a low speed (1500-2000 rpm) under no load for 2-3
minutes.
3.
Check whether the diesel engine runs normally or not. If it is abnormal, stop the
engine and have a check.
Warning:
•
Be sure to operate the engine in a good, ventilated place in order to avoid exhaust
poisoning.
•
Avoid letting hands, body & clothes entangle in output shaft, belt pulley, V-type belt
pulley and other moving parts, so as to prevent from getting injury.
•
Stop the engine first and then maintain the movable parts and other parts around it.
Make sure there are no tools and sundries in the body of the engine before operating.
Run engine for 5mins to warm up
Note:
•
The muffler becomes very hot during and immediately after
operation. Don’t touch it.
•
The air filter will inhale the air around itself when the engine works.
•
Don't let the hands, body and clothes approach the air filter to avoid injury.
After the engine becomes warm, put the speed lever on necessary position to run the
engine.
Note:
•
Be sure to use the speed lever to adjust the speed of engine.
•
Do not loosen the speed limit screw and fuel control screw; otherwise, the speed and
output of engine will be abnormal.
While the engine is running
