Kirstein Pronomic XL-12M1, Руководство по эксплуатации

Страница: 6 / 10

Pronomic XL-12M1
4
Pronomic XL-12M1 / ArtNr.: 00055469
2020-01-28
Product Description (rear panel)
1.
SD card slot: Use it to insert a SD card
with MP3 files
2.
USB slot: Use it to insert a USB flash
driver with MP3 files
3.
„Mode key“ and “Pause key“ “Play key“:
“Mode key” press to change from
USB/SD, Bluetooth and press “Play” to
play a song or “Pause” while playing a
song or stop the current song.
Bluetooth Pairing Name: XL-12M1
4.
Balanced Jack 6.3mm (1/4
”
) input: Can
connected with microphone
5.
Balanced XLR input: Can connected
with microphone.
MODE
Exchange between USB / SD /
Bluetooth
Play/Pause
Repeat
Last
Next
Bluetooth
6.
Input sensitivity switch; Line: normal mode
Mic: The input sensitivity is set to MIC
level, suitable for the direct connection of a
dynamic microphone. Do NOT use this
setting when connected to a mixer output!
7.
Balanced parallel XLR output: This
output is linked in parallel with the audio
input and is useful to connect another
amplifier.
8.
RCA Line input.
9.
Satellite Out: IMPORTANT: Before
turning the amplifier on, link the
subwoofer amplifier output to the
satellite speaker input!
10.
Power LED: When lit, the power is on.
Signal LED: When lit, the signal
presence at the audio input. CLIP LED:
When lit, the input signal level is
excessive and should be reduced
11.
Flat / Boost Switch, Flat (normal mode):
No equalization is applied (flat
frequency response).
Boost (pushed switch): ‘loudness’
equalization, only recommended for
background music at low volume levels.
12.
Top Satellite speaker volume control:
Turn it either clockwise to increase the
volume or counter clockwise to
decrease. Turn on lowest level
before
you switch on.
13.
Subwoofer volume control: Turn it
either clockwise to increase the bass or
counter clockwise to decrease. Set the
volume control to minimum and adjust
the Bass
after you switched on the
device.
14.
Fuse information
15.
Fuse: 220-240VAC~T3.15AL250V
16.
Power Switch: Push to turn ON / off the
amplifier. Before switching the amplifier
on, check all connections and turn fully
counter clockwise the volume control
17.
Power cord input: Before connecting
the power cord, check if the mains
corresponds to the voltage indicated on
the rating plate on the unit. Connect the
power cord only to a mains socket
outlet with a protective earthing
connection.