7
INSTALLATION
INSTALLATION
STEP 2: Mount the Battery Wand and Connect the Power Cable, If Applicable
For an optional satellite battery pack, 18V DC Power Supply, 18V DC Power Supply with daisy-chain connections, or C-size satellite
battery wand, the power source will be connected after the shading is installed.
Battery Wand
Install the Battery Wand Clips
■
■
Attach the battery wand clips to the headrail.
IMPORTANT:
Position the clips close to the power cable.
Mount the Battery Wand into the Battery Wand Clips
■
■
Position the battery wand with its socket toward the motor end of the shading.
■
■
Push the battery wand straight up into the battery wand clips until it snaps into place.
Check to make sure the battery wand is secure.
CAUTION:
Be sure the cables do not become pinched by the battery wand clips during
installation. Damage or overheating of components could result.
Plug the Power Cable into the Battery Wand
NOTE:
When power is connected to the motor, a green LED inside the
programming button housing will flash to indicate the shading is ready for
operation.
■
■
From the back of the shading headrail, connect the power cable (from the
motor side) into the socket on battery wand.
STEP 3: Install the Shading
If using the Optional Back Cover...
NOTE:
The optional back cover is used on inside and end mounts only.
■
■
Install the cover into the back cover brackets.
■
■
If necessary, trim the back cover to the desired width.
Place the socket
toward the motor end.
Battery
Wand
Power
Cable
Back
Cover
Back
Cover
Shading with
Battery Wand
All Other Shadings
