5
INSTALLATION
INSTALLATION — STANDARD PANEL SYSTEMS
4.
Hold the frame in the aligned position.
■
➤
Outside (OM) Mount.
Use a fastener to secure the center of the bottom frame. Check alignment, and then secure the side
frames within 3" of the bottom corners.
■
➤
Inside (IM) Mount.
Use fasteners to secure the side frames within 3" of the bottom
corners.
5.
Use fasteners to secure the frame near each hinge.
IMPORTANT:
Add fasteners at the bottom and top frame center. If using two or more
panels, place a screw in the top and bottom frame, close to where the panels meet. (The
screw should be slightly offset from the center so it will be less conspicuous.)
6.
Perform any necessary finish work to complete the installation (see page 24).
Hang Strip Installation
Hang Strip Behind (HSB) — Outside (OM) Mount
We suggest that light stop be installed on opening sides that do not have Hang Strip, generally the top and bottom sides. Light
stop is designed to minimize light gaps and provide a place to install the magnet base. If light stop is not ordered, a magnet spacer
will be sent automatically.
Step A. Install the Frame
1.
Attach the hinged hang strip first.
■
➤
The wide side of the hang strip should be against the mounting surface so that the hang strip projection is 1
1
⁄
8
".
NOTE:
To hold and mount the panel with the hang strip simultaneously, attach the two by placing a rubber band around the
two hinge barrels.
Hang Strip Behind (HSB)
Hang Strip to the Side (HSS)
INSTALLATION — HANG STRIP
