5
INSTALLATION
INSTALLATION
■
■
Attach the spacer blocks and installation brackets with #6 hex head mounting screws long
enough for a secure installation. (See chart below.) Longer screws are not provided.
■
➤
The top of the spacer blocks should be at the desired shade height.
■
➤
The front edges of the installation brackets must be level and aligned to each other.
CAUTION:
Use drywall anchors when mounting into drywall.
CAUTION:
The rear of the spacer blocks must be flush against a flat surface. Do not mount
spacer blocks and installation brackets on curved molding.
IMPORTANT:
The provided 1
1
⁄
2
" screws can only be used with a maximum of one
1
⁄
8
" shim.
You
will need to supply longer screws if additional clearance is required.
A minimum 1
1
⁄
4
" length of screw threads must extend beyond the last spacer block or shim. Use
appropriate wall anchors when mounting into drywall.
Mount the Headrail
NOTE:
A left stack design is shown throughout these
instructions. Procedures for a right stack design are the
same but at opposite sides of the fabric stack and headrail.
■
■
First, remove the moving rail brackets from the headrail.
■
➤
Remove the end plate from the left end of the
headrail.
■
➤
Slide out the moving rail brackets.
■
➤
Do not remove the cord tensioners from the
headrail.
■
■
Without reattaching the end plate, mount the headrail.
■
➤
Carefully align the headrail with the end marks on the mounting surface. (Headrail position cannot be easily adjusted after
the headrail is mounted.)
■
➤
Place the front groove on the headrail onto the front lip of the installation brackets.
■
➤
Rotate the rear of the headrail up and push back until the headrail snaps in place.
3" (Not provided; up to 1
1
∕
2
" of spacer blocks/shims)
2
1
∕
2
" (Not provided; up to 1
1
⁄
8
" of spacer blocks/shims)
Never use more than 1
1
∕
2
" of spacer blocks/shims!
2" (Not provided; up to
5
∕
8
" of spacer blocks/shims)
1
1
∕
4
" Minimum
Shim
Maximum of One
Shim with Provided
1
1
∕
2
" Screws
Do Not Remove
Cord Tensioners
Align Headrail with End Marks
Place Groove onto
Front of Bracket
Snap in Place
Longer Screw
(Not Provided)
Maximum
1
1
∕
2
"
