LIGHTING INSTRUCTIONS GRILL / ROTISSERIE
Section Four:
WARNING: IMPORTANT!
BEFORE LIGHTING. . .
Inspect the gas supply piping or hose prior to turning
the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use. Do not use
the Grill if the odor of gas is present. The pressure
regulator and hose assembly supplied with the unit
must be used. Never substitute regulators other than
those supplied with the grill. If a replacement is
necessary, contact the factory for proper replacement.
Screw the regulator (type QCC1) into the tank. Leak
check the hose and regulator connections with a soap
and water solution before operating the Grill.
TO LIGHT GRILL BURNER:
Turn all knobs to “OFF” then turn on the gas supply.
Always keep your face and body as far away from the
grill as possible when lighting.
Open the lid, push and turn the control knob to the
“LITE” position and immediately rotate the igniter knob
next to the burner knob.You’ll hear a snapping sound.
At the same time a spark will be provided at the grill
burner. It may be necessary to rotate the igniter knob
several times until the burner is lit.
If the burner does not light in 4 seconds, turn knobs to
“OFF” and wait 5 minutes before trying again for any
accumulated gas to dissipate.
TO MATCH LIGHT GRILL:
If the burner will not light after several attempts then
the burner can be match lit.
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Hold and pass a lit match over the
hole located on the top left for burner on the left (see
Fig. 20), or the right hole for the right burner. Push and
turn the control knob which is centered on the burner
where the lit match is located, to “LITE”. If the burner
does not light in 4 seconds turn the knob off, wait 5
minutes and try again.
TO LIGHT ROTISSERIE:
Open the lid, push and turn the control knob to the
“LITE” position.
Press the safety valve button, hold in, and begin turning
the rotary igniter button located next to the rotisserie
knob. It may be necessary to turn the igniter knob
several times until the burner lights.
WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance (rotisserie motor) is
equipped with a three-prong (grounding)
plug for your protection against shock
hazard and should be plugged directly into a
properly grounded three-prong receptacle.
DO NOT
cut or remove the grounding
prong from this plug.
The basting pan is
FOR ROTISSERIE USE
ONLY. DO NOT
use while grilling. (see
parts list for accessories).
USING THE GRILL & ROTISSERIE
Section Four:
Keep the rotisserie motor electric cord
away from the heated surfaces of the grill.
When not in use remove and store the
motor in a dry location.
Match Light Hole
12
FIG.20
Содержание PCA-2600L
Страница 28: ...NOTES 27 ...
Страница 29: ...NOTES 28 ...
