3
4
After about 3~4 hours of charging, the red LED will
be out, and the green LED will light up, which
indicates that the battery is fully charged, then you
can remove the battery from the charger.
The charger will enter the protection mode if the
temperature or the circuit is abnormal, and the LED
will flash yellow. Do not charge the battery by force at
this moment, just remove the battery and cut off the
power of the charger.
Note:
* The radio battery is not fully charged in the factory.
Before the initial use, please charge the new battery.
* KB-56B Li-poly battery of the company is applicable to
this radio.
* When charging the battery for the first time after purchase
or long-time storage (over 2 months), please repeat
charging several times for the battery to achieve normal
capacity. Meanwhile, please make sure the battery is
charged at least once every three months.
*
or the radio is not in the low battery alarm state; otherwise,
it will have bad effects on the battery's service life and
performance. Remove the battery from the charger
after charging.
* When the radio is in the low battery alarm state, please
recharge the battery before use. Do not turn the radio
power on by force; otherwise, it will have bad effects
on its service life and performance.
Do not recharge the battery if it has been fully charged
2.2 Installing/Removing the Battery
Installing the Battery:
Match the two bulges at the upper end of the
battery with the corresponding grooves on the top of
the radio and insert the battery.
Firmly press
the battery pack
downwards until
the battery latch
locks.
Removing the Battery:
To remove the battery pack, push the release latch
in the bottom of the radio forwards, the battery will
bounce up automatically. Then loose the belt clip
slightly and remove the battery pack away from the
radio.
Note:
* Do not short-circuit the battery terminals or dispose
battery in fire.
* Do not disassemble the battery casing by yourself.
