,
Low oil alarm
Indicator Light
(Red)
Low oil alarm system
6.GENERATOR USE
WARNING
2
2
.
To prevent electrical shock from faulty appliances,
the generator should be grounded. Connect a length
of heavy wire between the generator's ground
terminal and an external ground source.
Connections for standby power to a building's electrical
system must be made by a qualified electrician and must
comply with all applicable laws and electrical codes.
improper connections can allow electrical current from the
generator to backfeed into the utility lines. Such backfeed
may electrocute utility company workers or others who
contact the lines during a power outage, and when utility
power is restored, the generator may explode, burn, or
cause fires in the building's electrical system.
Maximum power is available in the first 30 minutes. For
continuous operation, do not exceed the rated power. In
either case, the total wattage of all appliances con-nected
must be considered.
Do not exceed the current limit specified for any one
receptacle.
Do not connect the generator to a household circuit. This
could cause the damage to the generator or to electrical
appliances in the house.
Do not modify or use the generator for other purposes than it is
intended for. Also observe the following when using the
generator.
D
o not connect generators in parallel.
D
o not connect an extension to the exhaust pipe.
When an extension cable is required, be sure to use a tough
rubber sheathed flexible cable.
Limit length of extension cables; less than 60 m for cables
if 2.5mm and less than 100m for cabes of 4.0 mm
Keep the generator away from other electric cables or wires
such as commercial power supply lines.
Electrical equipment(including lines and plug connections)
should not be defective.
CAUTION
The Low Oil alarm system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the crankcase falls
below a safe limit, the Low oil alarm system will automatically shut down the engine
(the engine switch will remain in the ON position).
Fuse
