-21-
-12-
5. STARTING-UP&RUNNING PROCEDURE
1. According to the step of 1-10, finish the starting-up procedure.
2. Ensure voltmeter indicates normal, (single phase: 230V, three phase: 400V)
3. Set the main switch to ON.
4. Observe the voltage is in the normal loaded range.
5. Preheat generator three minute without load after the set starting, then running
with load
6. The new generator set have a running-in period, the period is the initial 20
hours, only with 50% load during the running-in period, or it will shorten the set life.
7. Checks during the running
1) Whether there is abnormal sound or vibration;
2) Whether the engine misfires or runs rough;
3) Check the color of the exhaust. (Is it black or too white?)
If you notice any of the above-mentioned phenomenon happened, stop the engine
and find out the fault cause or contact with our agents.
If the engine has been running, the muffler will be very hot.
Be careful not to touch the muffler.
The diesel is adopted in the explosive motor. Never fill the diesel
which is inflammable when the generator is working. Be careful to fill
fuel and prevent fuel overflowing. Wipe up the overflowing fuel
immediately. Flame and fire are forbidden near the generator.
CAUTION
This guide is intended to give brief information for troubleshooting with no testing
or measuring instruments to check the unit.
However, testing and measuring instruments are required to diagnose parts and
components in many trouble cases.
If you cannot determine the cause by visual inspection, you should consult your
dealer whom you purchased this unit from.
10. SIMPLIFIED TROUBLESHOOTING GUIDE
1. Troubleshooting
DANGER
Rotating part
It's very dangerous to touch the rotating parts in the generator.
Stop the engine to service and maintain the inner parts of the unit.
DANGER
Electric shock
Don't touch the inner parts with high voltage during the running.
Stop the engine to service and maintain the inner structure.
CAUTION
Hot part
Attention the high temperature. Some parts of the generator surface and inside
are very hot, when operating, please see warning stickers on the generator.
To prevent scalding, pay attention to the warning marks attached to the
generator.
Close and lock the door, when running the super quiet generator. And don't
put hand and head into the engine to avoid scalding.
