- 31 -
Draft Control
This will control the pull of the 3-point implement. As
the load on the 3-point hitch changes due to various
soil conditions, the draft control system automatically
responds to these changes by either raising or lower-
ing the implement slightly to maintain a constant pull.
Place the position control lever in the lowest position
and set the implement pull with the draft control lever.
623O421A
Mixed Control
In draft control, when draft decreases, the implement
automatically lowers to increase draft. However, the
implement sometimes lowers too much. To limit the
degree, the implement can be lowered, set the posi-
tion control lever at the lowest working depth desire
for the implement. Lower the draft control lever to the
point where the implement is at the desired depth.
This stops the implement from going too deep and
causing loss of traction and ground speed.
(1) Ground surface
(2) Implement penetrate limit
(3) Soft soil
623O422A
How to Operate by Attaching Loader
You don’t need any extra control valve. The joystick
valve is attached only for the use of the loader.
The operation lever is extra attached on the right in
front of the driver’s seat within the cabin.
1. Connect two male couplers from boom cylinder to
the port E. F in front (on the right) of the tractor cabin.
2. Connect two male couplers from bucket cylinder to
the port G. H in front (on the right) of the tractor
cabin.
623O423A
