DCP 30 LX / DCP 30 SX
Issue: 11/2009
2
Intended Purpose
The DCP digital cinema projector can project any digital content with 2K resolution.
Any other or further use is not classified as an “intended purpose”. KINOTON cannot be
held liable for any damage resulting from different or extended operation.
As part of the “intended purpose” these tasks must be performed:
- observing all instructions and warnings contained in this manual
- inspecting the equipment for damage and correct function
- implementation of maintenance and repair work.
Guarantee and Liability
By reference KINOTON’s “General Terms of Business” apply. They are available to the
customer on conclusion of sale at the latest.
Guarantee and liability claims for damage to persons and property are invalid if due to
one of the following causes:
• improper use of digital projector
• improper assembly, commissioning, operating and maintenance of digital projector
• operation the digital projector with defective and / or non-functioning safety and
protection devices
• non-observance of instructions in the manual regarding transportation, storage,
assembly, commissioning, operation and maintenance
• modification of the projector without written authorisation from the manufacturer
• connecting to power other than as specified
• failure to monitor and/or replace parts subject to wear and tear
• improper repairs
• emergencies due to influence from outside bodies or force majeure.
1 .2
Important Safety Instructions for US Customers
When using your motion picture equipment, basic safety precautions should always be
followed, including the following:
• Read and understand all instructions before using.
• Care must be taken as burns can occur from touching hot parts.
• The equipment’s switch is provided with the symbols 0 indicating off and I indicating
on.
• Do not operate equipment with damaged wiring or if the appliance has been dam-
aged until it has been examined by qualified service personnel.
• Position any cord so that it will not be tripped over, pulled, or contact hot surfaces.
• If an extension cord is necessary, a cord with a current rating at least equal to that of
the appliance should be used. Cords rated for less amperage than the appliance may
overheat.
• Always disconnect appliance from electrical supply before cleaning and servicing.
