Kingspan BlueTruckMaster 200, Руководство по эксплуатации и безопасности, Страница: 11 / 16

BlueTruckMaster® – Operating and safety manual
Wires of the DC-powered pumps must also be correctly con-
nected, namely, the black wire must be connected to the nega-
tive and the red wire connected to the positive pole.
More information can be found in the pump manual included with the de-
vice.
11. VEHICLE REFUELLING
Before refuelling, the BlueTruckMaster® pump must be connected to a
power source (see Point 10). Also, when using BlueTruckMaster® 900, make
sure that the ball shut-off valve before the pump is open. Turn on the pump
using the switch and insert the filling nozzle into the AdBlue® tank inlet.
Refuelling will start within two minutes after pressing the nozzle pushbut-
ton.
When handling tanks that are not equipped with automatic fill-
ing nozzles, pay attention to prevent tank overflow as they do
not automatically cut off the flow.
Do not start pumping when BlueTruckMaster® is empty. Therefore, the
pump should be shut off immediately after draining the tank. Otherwise the
pump may be damaged. The maximum pump running time is indicated on
the nameplate or in the pump manual that is included with the device. Do
not exceed the allotted time because otherwise the pump will get over-
heated.
12. FLOWMETER
Depending on the specifications, tanks can be equipped with
a flowmeter. Information on flowmeter usage can be found in
a separate guide included with the device.