Installation Instructions
for Lacerta Range - IP
44
PIR LED Floodlights
Part Nos: LEDFLPIR
10
E, LEDFLPIR
18
E & LEDFLPIR
27
E
3
.
Secure the waterproof ring and nut tightly.
4
. To set the floodlight direction, loosen the screws on the sides of the mounting bracket
(underneath the housing) and adjust the floodlight angle, then re-tighten all screws
securely.
Note: Leave a minimum of
200
mm above the fitting.
L
N
L
N
5
. Mark the hole positions for the fixing bracket onto the wall. Drill and plug the wall at
the marked positions,. Screw the fixing bracket to the wall with suitable screws (not
supplied).
IMPORTANT
This product should be installed by a competent person and in accordance with the
current IET Wiring Regulations. If in doubt, consult a qualified electrician.
GENERAL INFORMATION
IMPORTANT
•
Never look directly into the LED light source.
•
Do not use near flammable materials
•
Do not use near paddling pools, fountains, ponds or similar water sources
•
Do not place in water or other liquids
•
Never operate with wet hands
•
Never cover the fitting
•
Never operate when the casing is open, or when the wiring casing is missing or
damaged, or when the protective screen is defective
•
Never spray this unit and never attempt t0 clean it with a steam pressure
cleaner as this can damage the insulation seals
•
Never attempt to repair this unit yourself, there are no user serviceable parts
1
.
Loosen the
5
cover screws.
INSTALLATION
2
.
Connect the wires to the connector block as shown, and re-install the five screws.
L
- Brown
- Yellow/Green
N
- Blue
18
W - LEDFL
18
E /
27
W LEDFL
28
E
6
mm
6
mm
8
mm
80
mm
10
W - LEDFL
10
E
6
mm
6
mm
45
mm
8
m
m
8
m
m
LEDFLPIR 101827E Ins.qxp_a 11/12/2014 11:23 Page 1
