IMPORTANT:
This product should be installed by a
competent person and in accordance with
the IET Wiring Regulations.
If in doubt, consult a qualified electrician.
These instructions should be read carefully
prior to any installation and retained after
completion for further reference and
maintenance. Please give these
instructions to the building owner/occupier
after installation.
Always turn off the power source before
commencing work on this device.
Part numbers:
LEDFL
10
, LEDFL
20
, LEDFL
30, LEDFL50,
LEDFL80, LEDFL120 & LEDFL150
Installation / Operating
Instructions for
IP65 LED Floodlight Fittings
IMPORTANT INFORMATION
INSTALLATION INSTRUCTIONS
This luminaire is water resistant to IP
65
but
it is advisable, wherever possible, to locate it
in a sheltered location. No modification
should be made to the casing to preserve the
moisture properties and warranty.
This fitting is supplied pre-wired with
0.9
M
of three core cable (Live, Neutral and Earth).
This cable can
NOT
be removed. Connection
must be made via a suitable terminal box.
Should the flex become damaged it should
be replaced with cable of the same
specification and only by a competent
person. To avoid a heat build up it is
advisable that a clear air gap is left around
the luminaire and the front face should be at
least
500
mm away from any combustible
surface. The supplied bracket should be used
at all times for mounting.
TECHNICAL INFORMATION
This appliance is designed to work with a
mains voltage of
100
V to
250
V AC
50
Hz.
It should be wired to an appropriately fused
and protected source.
Lumen Output:
10
W
700
lm
20
W
1400
lm
30
W
2100
lm
50
W
3500
lm
80
W
5600
lm
120
W
9000
lm
150
W
10500
lm
LEDFL10 20 30 50 80 120 150 Ins.qxp_MR16 11/02/2016 12:
