I N S T R U C T I O N M A N U A L
Specialists in Digital TV Distribution Solutions
DIGI6VHF
VHF OUTDOOR TV ANTENNA
PRINTING SPECIFICATIONS:
DIGI6VHF INSTRUCTION MANUAL
Dimensions: 210 (W) x 297 (H) mm (A4)
Stock:
80gsm paper
Print:
4 colour CMYK both sides
Finish:
Matt stock
Part Number:
311153
Drawing Number:
52500-1
ARTWORK SUMMARY
DRAWING #
52500-1
PART #
311153
ECO #
N/A
W-15-6 VHF Yagi Television Antenna Assembly Instructions
towards
transmitter
directors
reflector
The W-15-6 is a quality VHF yagi TV Antenna which provides high gain over 174- 230MHz, ch's 6 to 12.
This antenna features a high overall performance in a modest size. A matching balun ensures
maximum energy of high signal quality is transferred to the coax cable for transmisson to the Television.
How to assemble:
1/ loosen a boom clamp wing nut, insert element, rotate 90
°
to boom, centre, re-tighten & repeat.
2/ a) slip weather boot on to coaxial cable (excluded) and fit an F connector to the coax cable.
b) screw the F connector on to the dipole, finally sliding the weather boot over the joined connectors.
c) fit the dipole to the boom in the position shown, securing with wing nut.
3/ fix the boom clamp to the antenna and fit complete antenna to mast (excluded) by tightening wing nuts.
The DIGI6VHF is a quality VHF yagi TV Antenna which provides high gain over 174- 230MHz,
Australian channels 6 to 12. This antenna features a high overall performance with a matching balun
to ensure the maximum amount of signal is transferred to the coax cable for transmisson to the
Television.
Assembly Instructions:
1/ loosen boom clamp wing nut, insert element, rotate 90° to boom, centre per the mark on the
element, re-tighten & repeat for each director & the reflector.
2/ a) fit the folded dipole to the boom in the position shown, securing with wing nut.
b) slip boot onto the coaxial cable and fit an F connector to the coax cable.
c) screw the F connector on to the balun, being careful not to over-tighten and slide the boot
over the connector. For best results, tape the boot onto the cable to prevent it sliding off the
connector. Self-amalgamating tape is best if available, other PVC tape will suffice.
3/ loosen the wing nuts on the mounting bracket to fit over the antenna mast. Then tighten the
wing nuts, ensuring the antenna is pointing towards the TV transmitter. Cable tie or tape the coax
cable to the mounting pole, ensuring there are no sharp bends on the cable during this process.
Rubber
Boot
Coaxial
cable
W-15-6 VHF Yagi Television Antenna
Assembly
Instructions
towards
transmitter
directors
The W-15-6 is a quality VHF yagi TV Antenna which provides high gain over 174- 230MHz, ch's 6 to 12.
This antenna features a high overall performance in a modest size. A matching balun ensures
maximum energy of high signal quality is transferred
to the coax cable for transmisson to the Television.
How to assemble:
1/ loosen a boom clamp wing nut, insert element, rotate 90
°
to boom, centre, re-tighten & repeat.
2/ a) slip weather boot on to coaxial cable (excluded) and an F connector to the coax cable.
b) screw the F connector on to the dipole,
the weather boot over the joined connectors.
c)
the dipole to the boom in the position shown, securing with wing nut.
3/
the boom clamp to the antenna and complete antenna to mast (excluded) by tightening wing nuts.
reflector
Folded
dipole
boom clamp
mounting
bracket
balun
