Revision 2 Date: 11 Jun 2020 Page 8 of 12
press [OK] to save settings.
Note that if invalid threshold values have been entered,
the unit will automatically exit Threshold Setup mode and return to home display
without saving those values.
➎
Use [►] to select the next wavelength and, repeat steps
➌
~
➍
above
to set and save the respective threshold values. Do the same until the
threshold values for all wavelengths are setup and saved.
➏
To exit Threshold Setup mode, press [OFF] to return to home display.
3.7 Measurement with Pass/fail Display Mode
When performing measurements in this mode, measurement results (based
on the threshold values set in section 3.6) for each wavelength will be
automatically displayed. The symbols used to indicate measurement results
are as below,
Alert (displayed as “
!
”)
Pass (displayed as “
√
”)
Fail (displayed as “ x
”)
To activate Pass/Fail Display mode:
Press and hold [▲] at home display. Select a
threshold group number from the available 01,
02, 03 using [▲, ▼]. Press [OK]. See an
example of the display on the right.
To deactivate Pass/Fail Display mode:
Press and hold [OK].
Threshold values stored in
group,01 have been selected
for measurement tests.
