ASSEMBLY INSTRUCTIONS
FIGURE 15
Quill
INSTALLING THE CHUCK
1. Clean out the tapered hole in the chuck, clean the spindle nose with
a clean cloth. Make sure there are no foreign particles sticking to the
surfaces. The slightest piece of dirt on the spindle nose or on the
chuck will prevent the chuck from seating properly. This will cause
the drill to “wobble”.
2. Slide the chuck up over the arbor as illustrated in Fig.15.
3. Unlock the table support lock and raise the table so that it is two
inches below the tip of the chuck.
4. Turn the chuck sleeve clockwise and open jaws in chuck completely.
5. Turn the feed handles counterclockwise and force the chuck against
the table until the chuck is secure.(Fig.16).
REMOVING CHUCK AND ARBOR
1. With the switch off, adjust the depth scale to hold the drill at a depth
of 3” (see instructions for “Locking chuck at desired height”).
2. Align key holes in spindle and quill by rotating the chuck by hand.
3. Insert key drift into key holes.
4. Tap key drift lightly until the chuck and arbor fall out of the spindle.
NOTE
: Place one hand below the chuck to catch it when it falls out.
(Fig.17).
INSTALLING LIGHT BULB
1. Install a light bulb (no larger that 60Watts) into the socket inside the
head. (Fig.18).
Arbor
Chuck
FIGURE 16
Feed
handle
FIGURE 18
FIGURE 17
Key
drift
Chuck
sleeve
Chuck
body
