SETTING UP AND OPERATING
THE AIR CLEANER
UNPACKING
The air cleaner is shipped complete in one carton. Carefully unpack the Air
Cleaner and all loose items from the carton.
WARNING: DO NOT LIFT THE
AIR CLEANER BY ITS POWER CORD.
SETTING UP THE AIR CLEANER
Operational tips:
• This air cleaner will work best if it is located away from corners and heating/
cooling vents.
• This air cleaner is specifically designed to circulate and filter non-metalic dust,
which is generated throughout the work area.
Hanging air cleaner from ceiling
1) This air cleaner can be hung from the ceiling. Install the four air cleaner eye
bolts (A) Fig.3 and hex. nuts (B) to the top of the air cleaner housing.
2) Tighten the hex. nuts (B) to secure the eye bolts.
3) Mount ceiling hooks and chains (not included) properly rated for hanging this
unit (minimum 90 lbs capacity) in the ceiling to mount the air cleaner.
WARNING!
Ceiling hooks must be anchored to the building structure (load bear-
ing studs or joists), which will support a minimum of at least 90 pounds. Never
mount to drywall or false ceiling grids. Hang/mount unit with a 7ft. clearance
from the floor.
OPERATION WITHOUT USING THE REMOTE CONTROL
WARNING!
NEVER OPERATE THE AIR CLEANER WITHOUT THE INNER
AND OUTER FILTERS PROPERLY INSTALLED IN THE AIR CLEANER
HOUSING.
1) Place the air filter on the floor or a workbench.
2) Connect the power cord to the power source.
3) Push the switch (A) Fig.4 downwards to the “Without Remote Control” posi-
tion on the control panel.
4) Pull the speed setting switch chain (B) Fig.4 to turn the fan ON. The air
cleaner should run smoothly without abnormal noises and with little vibration.
5) Pull the speed setting switch chain (B) to cycle through the 3 speed settings
and once again to turn OFF the fan.
OPERATION USING THE REMOTE CONTROL
WARNING!
NEVER OPERATE THE AIR CLEANER WITHOUT THE INNER
AND OUTER FILTERS PROPERLY INSTALLED IN THE AIR CLEANER
HOUSING.
1) Place the air filter on the floor or a workbench.
2) Connect the power cord to the power source.
3) Push the switch (A) Fig.4 upwards to the “With Remote Control” position on
the control panel.
4) Push the On/Timer button (A) Fig.5 on the remote control to turn the air
cleaner ON and then push the OFF button (B) to turn it OFF.
FIGURE 3
FIGURE 4
FIGURE 5