Famulus reflex M
Picture size chart
Technical data
Famulus reflex M – No. 6090
Ohp with metal halide lamp 100 V/300 W, lamp life 750 hours;
LED for lamp change, working surface 285 x 285 mm, for DIN A 4
transparencies (vertical and horizontal). 3-element vario-focal lens
f = 280–300 mm, automatic focusing device for upward projection.
Overheating device, quick fuse change. Electronic power supply with
voltage stabilizer 100–130 V AC and 200–250 V AC, 50–60 Hz.
Power consumption: 350 Watt. Supplied with carrying bag.
Dim.: 430 x 293 x 110/455 mm
Weight: 4.6 kg
Lamp change
Metal halide lamp HTI 300 W/DX, 750 h, No. 6093
Do not use any other type of lamp!
Important:
The metal halide lamp reaches high temperatures and operates under
high pressure. Inside the lamp house some parts are under high
voltage. Keep off.
Switch off the projector, disconnect it from the mains and let it cool
down for 20 minutes before changing the lamp. Once it is cold, the
lamp is no longer under pressure and therefore harmless.
The defective lamp should be disposed of according to local regula-
tions. Don´t throw it away with the household garbage.
Turn out the safety screw (13) at the projection head (9).
Press the release button (13 a) and take off the top (fig. 3 + 4).
Take out the defective lamp.
Hold the new lamp only at its metal parts – remove existing nuts
first, they are not needed. Carefully insert the new lamp in the centre
of the metal sockets until it engages.
The lamp is in its correct position if it fits into the grooves of the
sockets, and the metal seal on the lamp cylinder points sidewards to
the fan (fig. 5).
Never touch the bulb with your bare fingers. If it happens, clean the
bulb with a soft cloth and alcohol.
Put back the top of the projection head. First insert the two front
hooks of the cover into the slots of the bottom, and then close the
case until the catch on the rear side engages.
Don´t forget to fix the safety screw (13) (fig. 3 + 4).
Switch on the projector and press the reset button (5) 3 seconds,
e. g. with the top of a ball-point pen, until the LED flashes up for a
moment. Thus the lamp life indicator is put back to “0”.
Picture width in m
Distance in m
6090 GB
0108
4
12 / 843 818 Subject to alterations Printed in Germany
KINDERMANN GmbH
•
Kindermannstrasse 2
•
D-97199 Ochsenfurt
Tel.: +49 (0) 9331/93-0 • Fax: 93-239 • www.kindermann.com • [email protected]
When ordering spare parts, always quote the reference number and
serial number of your projector!
GB
1
1
2
3
2
3
4
Disposal of this product
If the dust bin on the label is crossed out the product should not be disposed
of along with the normal household garbage to prevent possible harm to
the environment or human health.
