Kinco FD425-CA-000, Руководство пользователя, Страница: 149 / 206

146
D0.07 26900008
Communication
encoder data reset
write ：
1: clear encoder status
2: read fault word
3: Clear encoder status and
multi-turn data
8: Reset status flag
9: Clear multi-lap data
10:
write 8 and 9
read ：
bit 0: 1 = Commands can be
entered
bit 1: 1 =
The last
command is executed
0 / RW
D0.08 2FF02310
Jog speed setting
Speed in jog mode ， unit
rpm
0 0~5000 RW
D0.09 23400D08 Keba
0:
default
1:
turn on remote node
40
:
Compatible with 2S panel
parameter flags
0 0
、
1
、
40 RW
9.1 F001
This panel menu contains all controller values which can be shown by the LED display when it’s in the monitor mode
(see 4.2) and no error or warning is shown. On the LED panel, select the panel address of the value to be displayed
and press SET. After leaving the menu, the selected value is displayed. To make this selection permanent it must be
saved through d2.00 in F002.
Table 9-1-2: Panel F001 setting
Panel
address Internal
address
Name Description Default Range RWS
d1.00 2FF00F20 Soft_Version_LED Firmware version, display at the LED. / / R
d1.02 2FF01008 Motor_IIt_Rate
Displays the rate of real iit and max iit
of the motor.
0 0-100% R
d1.04 2FF01108 Drive_IIt_Rate
Display the rate of real iit and max iit
of the controller.
0 0-100% R
d1.06 2FF01208 Chop_Power_Rate
Display the rate of real power and
rated power of the chopper.
0 0-100% R
d1.08 60F70B10 Temp_Device
temperature of controller, unit: ℃ ,
/ / R
d1.09 60F71210 Real_DCBUS DC bus voltage, unit: V, / / R