Bell
™
Wall Mount - KLV50/52/55/57
Installation
P.O. Box 60080
•
16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-56
66 • FAX
626/330-3861
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS!
WARNING - To reduce the risk of FIRE OR INJURY TO PERSONS: Do not overdrive the fixtures with greater
than 12 volts or fixture over-heating and short lamp life will occur. Do not overload the transformer by
installing (or relamping) higher wattage lamps than planned. Note: Total wattage of all lamps connected to one
transformer must not exceed the capacity of that transformer. Do not install luminaire within 10 feet (3.04m) of a
pool, spa or fountain.
SAFETY WARNING: When relamping be sure electrical supply is OFF. Lighted lamp is HOT! Low voltage
fixtures can become very hot depending on the lamp wattage used. Glass lenses and metal areas above &
around the lamp can become hot enough to blister hands. Use discretion when touching fixture and be sure to
allow fixture to cool before relamping. Particular care should be taken not to locate fixture where small children
can reach them if higher wattages are used. NOT INTENDED FOR INDOOR USE.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.
All electrical work should be done by a qualified electrician.
KEEP THIS SHEET FOR FUTURE REFERENCE.
Tools Required
:
Flat Blade Screwdriver
3/32
”
Allen Wrench
Installation Instructions:
Make certain electrical supply is
OFF
before starting fixture installation.
1. Attach mounting plate to J-box with screws provided. Apply clear silicone to
inside of wall canopy to ensure water tightness.
2. Connect fixture cable to main
system cable.
3. Attach wall canopy and fixture to
mounting plate. Secure with two
(2) flat head screws provided.
KLV50 / KLV52
KLV55 / KLV57
4. Remove lens frame and lens.
(Step 4 not required on L.E.D.
version, for L.E.D. fixture skip to
step 6).
Revision
7
/
16
/10 EC
100715008
Status 7
Part No. 95620
!
!
!
5.
Install lamp of type & wattage as shown on
fixture label and chart. Reinstall lens and
lens frame. (Step 5 not required on L.E.D.
version, for L.E.D. fixture skip to step 6).
