Install the HAB™ Mounting Plate
Use the HAB™ mounting plate as a template to mark pilot holes on the mounting
surface. Choose holes so that you can mount the plate using at least four of the widely
spaced holes. Use a level to ensure that the plate is level. Refer to the Mounting
Surface section below for mounting surface specifications.
Mounting Surface
If you are anchoring the mounting plate into wood studs use at least four (one at each
corner) #14 (1/4") wood screws with washers. The screws must be long enough to
penetrate at least 1½" into the studs.
If you are anchoring into plywood wall material, the plywood must be at least ¾ inch
thick. Use four (one at each corner) #14 (1/4") wood screws with washers. The screws
must be long enough to penetrate at least ¼ inch beyond the back of the plywood. You
can also use four (one at each corner) heavy-duty ¼-inch toggle bolts, rated for at least
250 lb.
If you are anchoring into metal studs, the studs must be a minimum of 18 gauge. Use
at least four (one at each corner) #14 sheet metal screws with washers. The screws
must be long enough to penetrate at least three threads beyond the stud. If you’re
installing onto a wall with metal studs less than 18 gauge, a mounting surface (such as
KiloVault
®
LLC • 330 Codman Hill Road, Boxborough, MA 01719 • +1 (888) 218-5924 •
•
4 of 9
Wall Mounting Plate - See dimensions in the Physical
Specifications section.
Wall Mounting Plate attached to the back of the HAB.
