Kikusui TOS9200, Руководство по эксплуатации

Страница: 132 / 172

5-2 Controlling the TOS6200 TOS9200/9201
Setting the PASS hold time
On the TOS6200, press the SYSTEM key. The LED lights up on the SYSTEM key,
and the System Settings screen (SYSTEM 1) appears.
The PASS hold time must be set to HOLD so that the TOS9200/TOS9201 can catch
PASS signals from the TOS6200 without failure.
When the TOS9200/TOS9201 recognizes the PASS signal from the TOS6200, the
tester enters the INTERVAL mode, regardless of the pass hold time settings.
For details on the setting procedure, see the Operation Manual for the TOS6200.
Setting test conditions
It is necessary to preset test conditions for the TOS6200 in panel memory.
In the TOS6200, memories 1 through 18 contain factory settings that conform to the
relevant safety standards. To add new test conditions, use memories 19 through 99.
5.1.3 Settings on the TOS9200
Interface settings
On the TOS9200/9201, press the SHIFT + SYSTEM /I/F keys. The LED then lights
up on the SYSTEM /I/F key, and the Interface Settings screen (INTERFACE)
appears.
On this screen, make the settings speci
fi ed below.
SPEED (baud rate) : 19 200 bps
DATA (data length) : 8 bits
PARITY : NONE
STOP (stop bit) : 2 bits
Upon completion of the above settings, turn the POWER switch off and then on
again.
For details on the setting procedure, see "3.11 Interface Settings".
Setting LOW/GUARD for the GND
To conduct an earth continuity test together with other tests, set GND to LOW on
the ACW2, DCW2, and IR2 screens.
If GND is set to GUARD, the internal resistor of the TOS6200 is connected in paral-
lel with the tester’s ammeter, leading to measurement errors in the ammeter. To use
the TOS6200, do not connect the TOS6200’s HIGH or LOW terminal to the tester’s
terminal. Otherwise, set GND to LOW.