Kikusui PWX1500H, Руководство пользователя

Страница: 47 / 131

PWX
47
CONFIG Settings
Basic Functions
2
CF06 CV control using an Vext or Rext
p. 67
Selects whether constant voltage will be controlled by an external voltage (Vext) or an exter-
nal resistance (Rext) (the J1 connector).
This is set to “oFF” when the panel settings are reset (CF00) and when a preset memory
entry is recalled.
You can only specify this parameter when the PWX series is being used as a master unit
.
CF07 CV/CC control range parameter
p. 67 , p. 69
Selects the range that is used when controlling constant current and constant voltage with an
external voltage or an external resistance (the J1 connector).
You can only specify this parameter when the PWX series is being used as a master unit
.
CF08 Range during voltage and current monitoring
p. 75
Selects the range during voltage and current monitoring.
CF09 External control parameter for turning output on and off
p. 71
Selects whether an external contact (the J1 connector) will be used to turn output on and off.
This is set to “oFF” when the panel settings are reset (CF00) and when a preset memory
entry is recalled.
You can only specify this parameter when the PWX series is being used as a master unit
.
CF10 External control logic parameter for turning output on and off
p. 71
Sets the logic that is used when an external contact (the J1 connector) is being used to turn
output on and off.
You can only specify this parameter when the PWX series is being used as a master unit
.
See
Value Parameter description
oFF Control will not be performed (factory default setting).
on Control will be performed.
See
Value Parameter description
Lo 0 V to 5 V (factory default setting)
Hi 0 V to 10 V
See
Value Parameter description
Lo 0 V to 5 V (factory default setting)
Hi 0 V to 10 V
See
Value Parameter description
oFF External control is not performed (factory default setting).
on External control is performed.
See
Value Parameter description
Lo Output is turned on when a LOW signal (0 V to 0.5 V) or short-circuit is received
(factory default setting).
Hi Output is turned on when a HIGH signal(4.5 V to 5 V) or open-circuit is received.