Kikusui PWX1500H, Руководство пользователя

Страница: 42 / 131

42
PWX
CONFIG Settings
Use the CONFIG settings to set the PWX series system configuration. You can set and dis-
play the following parameters in the CONFIG settings. The CONFIG parameters are listed in
a separate document (included with this manual).
Effects: ● indicates a parameter that may be affected when the panel settings are reset (CF00) or when a
preset memory entry is loaded.
▼ indicates a parameter that may be affected when the master unit, the slave unit, or the number
of units is changed (CF01).
■ indicates a parameter that may be affected when the LAN interface settings are reset (CF40:
LCi/dEF).
In the “Note” column, “A” indicates a parameter that is applied immediately, “B” indicates a parameter
that is applied when the PWX series is turned on, and “C” indicates a parameter that is applied when
CF40 “APPL” is executed.
Parameter number,
CF (CONFIG)
+ a two-digit number
Setting display
Lit
CONFIG setting and
display examples
Display
switching Parameter
number
Setting or display description Effect Note
SYSTEM
CF00
1
Resets the panel settings — A
CF01 Master-slave parallel operation parameter ▼ B
CF02
1
Power-on status parameter — B
CF03 Method for clearing OHP, FAN, and AC-FAIL alarms — B
CF04
1 Memory content display parameter — A
CF05
1
CC control using an Vext or Rext ● A
CF06
1 CV control using an Vext or Rext
●
A
CF07
1
CV/CC control range parameter — A
CF08 Range during voltage and current monitoring — A
CF09
1 External control parameter for turning output on and off
●
▼
A
CF10
1
External control logic parameter for turning output on and off
▼
A
CF11 Bleeder on/off parameter — A
CF12
1
Output-on startup state parameter ▼ A
CF13 Detection time of OCP activation — A
CF14
1 Current setting limit
●
▼
A
CF15
1
Voltage setting limit ●
▼
A
CF16 Panel display brightness setting — A
CF17 Communication monitor timer setting — A
CF18
2
Internal resistance setting
▼
A
CF19
3
Current and power display on slave units for master-slave parallel
operation — A
INTER-
FACE CF20 LAN interface parameter
▼
■
4 B
CF21 Command language parameter
▼
B
CF22 Emulation parameter during remote control
▼
B
CF23 SCPI communication error display parameter ▼ A
CF24 Multichannel (VMCB) domain number parameter
▼
■
4
B or C
CF25 Multichannel (VMCB) channel number
▼
■
4
B or C
LAN
5
CF30 IP address display (1) ▼ ─
CF31 IP address display (2)
▼ ─
CF32 IP address display (3) ▼ ─
CF33 IP address display (4) ▼ ─
CF34 MAC address display (1) and (2)
▼ ─
CF35 MAC address display (3) and (4)
▼
─
CF36 MAC address display (5) and (6) ▼
─
CF40 Resets (LCI/ DEF) or applies (APPL) the LAN interface settings ▼ A
CF41 IP address assignment method
▼
■ B or C
CF42 Manual IP address setting (1)
▼
■ B or C
CF43 Manual IP address setting (2)
▼
■ B or C