Kikusui PWX1500H, Руководство пользователя

Страница: 15 / 131

PWX
15
1
Inst
allation
and Prep
aratio
n
Turning the Power On
Turning the POWER switch on
p.59
When you turn the POWER switch on for the first time after purchase, the PWX series starts
with its factory default settings. Subsequent times that you turn the PWX series on, it starts
with the panel settings (excluding the output on/off setting) that were in use immediately
before the POWER switch was turned off.
p.46
You can use the CONFIG settings (CF02) to select how the PWX series starts when the
POWER switch is turned on.
1
Check that the power cord is connected correctly.
p.21
2
Check that the OUTPUT terminal cover is attached.
When the product is shipped from the factory, the OUTPUT terminal cover is not
attached.
3
Turn the POWER switch on ( ).
All the LEDs light, and then the voltmeter and the ammeter display the following
sequence of information: the rated voltage and rated current, the firmware version
number, and then the build number. Each item is displayed for approximately 1 sec-
ond.
After a few seconds, the PWX series enters the operation standby state (the output
value is displayed).
 Inrush current
When the POWER switch is turned on, an inrush current of up to 70 A flows. Check that suffi-
cient current capacity is available in the AC power line or the switchboard, particularly if you
are using multiple PWX series and turning on their POWER switches simultaneously.
WARNING
Risk of electric shock. Regardless of whether load cables are connected to the output
terminals, be sure to attach the OUTPUT terminal cover before turning the POWER
switch on.
CAUTION
You can use the CONFIG settings to set how the PWX series starts when you turn the
POWER switch on. Depending on the setting, the output may be turned on automatically
when the POWER switch is turned on. In case that you connect a load without setting OVP
and OCP to the appropriate values, the load may be damaged if output automatically turns
on at the PWX series power-on.
See
See
See
Firmware version display
(Version 1.00 in this example)
Rated voltage and rated current display
(The PWX750MLF is being used in this
example.)
Build number display
(Build number BLD 0120 in this example.)