Kikusui PFX2532, Руководство по эксплуатации

Страница: 46 / 142

46
PFX2532
Configuring the PFX2532
Setting the channel numbers
To use the PFX2532, you need to set a unique number called channel number to identify the
PFX2532 and also to set the IP address. If you are using only a single PFX2532, you do not need to
set the channel number.
Tests can be performed under different conditions for each channel number.
Assign a unique number to each PFX2532.
Setting the vibration sensor
The PFX2532 has a built-in vibration sensor.
If set to on, when the PFX2532 detects large shaking (around magnitude 5 and higher) or shock
during charge / discharge testing, a SHOCK DETECT alarm will be activated, and the output will be
turned off. The vibration sensor sensitivity is fixed.
Set it before turning on the power.
To release the alarm caused by the vibration sensor, execute an alarm release command from
BPChecker3000.
Valid channel numbers 1 to 7
SH DET switch Vibration sensor
0 Off (factory default setting)
1 On
• The vibration sensor is designed not to respond to single shock (such as bumping), but it may
abort a test due to vibration or shock other than earthquakes. Take this into consideration when
you turn on the vibration sensor (set the switch to 1).
• If you want to set the vibration sensor to on (set the switch to 1), install the PFX2532 as upright as
possible in a location without vibration or the like. If the installation is inappropriate, the SHOCK
DETECT alarm may be activated preventing you from performing tests.