Kikusui PFX2515, Руководство по эксплуатации, Страница: 56 / 104

56
PFX2512_CE
Setting the Model ID
Releasing the warning
Remove the cause of warning occurrence.
If you cannot clear the warning even when all of the causes of the warning occurrence are
eliminated, the PFX2512 may have malfunctioned. If this happens, stop using the PFX2512 and
contact your Kikusui agent or distributor.
Setting the Model ID
p. 16
The operating range of charge and discharge (maximum voltage / maximum current) for the
possible charge and discharge test depends on the DC power supply and the Electronic load
connected with the PFX2512. Model IDs are defined for the various combinations of device connec-
tions.
The factory default setting, Model ID is set for the following combinations.
p. 57
The model ID can be set using the application software by the PC.
See
Model ID Combination
7101 PWR800L, PLZ1004W (H range)
See
Model ID DC power
supply Electronic load Maximum power
for the charge
*1
*1. The value of power indicated above may not be used because of the route loss. (
p. 16
)
Maximum power
for the discharge
7101
*2
*2. Factory default settings
PWR800L PLZ1004W (H range) 800 W 1000 W
7102 PWR800L PLZ1004W (M range) 800 W 1000 W
7103 PWR1600L PLZ1004W (2 units parallel ) 1600 W 2000 W
7104 PWR800L PLZ334W (H range) 800 W 330 W
7106 PWR1600L PLZ1004W (H range) 1600 W 1000 W
7107 PAS10-70 PLZ1004W (H range) 700 W 1000 W
7108 PAS20-36 PLZ1004W (H range) 720 W 1000 W
7109 PAS20-54 PLZ1004W (H range) 1080 W 1000 W
7110 PAS40-27 PLZ1004W (H range) 1080 W 1000 W
7111 PWR800L PLZ164W (H range) 800 W 165 W
7112 PAS10-35 PLZ334W (H range) 350 W 330 W
See
If the selected model ID's is not applied to the equipment configured in the system, the charge
and discharge testing cannot be executed. In case of model ID's are set, please make sure they are
set properly.