Kikusui PBZ20-20, Руководство пользователя, Страница: 148 / 170

148
PBZ
Synchronization Feature
Configuring the Synchronization Feature
Set one unit as the master unit, and set the other units as either slave units or slave end units
as the situation demands. Set units as slave end units if you want to use TRIG OUT signals.
You can connect any unit from the PBZ series.
• Master unit (SYNC MASTER)
• Slave unit (SYNC SLAVE)
• Slave end unit (SYNC SLAVE END)
p. 89
Use to set the synchronization feature. When output is on, you cannot change this
setting.
The Functions of the TRIG IN and TRIG OUT Terminals
When the synchronization feature has been set
Depending on whether the unit is the master unit, a slave unit, or a slave end unit, the TRIG
IN and TRIG OUT terminals function as trigger I/O (TRIG IN and TRIG OUT) or
synchronization control signal I/O (SYNC IN and SYNC OUT).
CONFIG settings
The following limitations exist when PBZs have been connected and set for synchronization.
See
CONFIG
Terminal SYNC MASTER
(master unit) SYNC SLAVE
(slave unit) SYNC SLAVE END
(slave end unit)
TRIG IN Trigger input (TRIG IN)
p. 106
Synchronization control
signal input
(SYNC IN)
1
1
This terminal can only be used for this purpose.
Synchronization control
signal input
(SYNC IN)
1
TRIG OUT Synchronization control
signal output
(SYNC OUT)
1
Synchronization control
signal output
(SYNC OUT)
1
Trigger output (TRIG OUT)
p. 106
Function SYNC MASTER
(master unit) SYNC SLAVE
(slave unit) SYNC SLAVE END
(slave end unit)
TRIG IN You can set the polarity.
You cannot select the
polarity (“---” is displayed).
You cannot select the
polarity (“---” is displayed).
TRIG OUT You cannot select the
polarity (“---” is displayed). You can set the polarity.
See
See