Kikusui PBZ20-20, Руководство пользователя, Страница: 113 / 170

PBZ
113
Executing Programs
4
Se
quences
Executing Programs (RUN)
1
Press RUN/PAUSE or STOP.
The sequence start screen (SEQ EXECUTION) appears. If you do not want to start
program execution, press a key other than the RUN/PAUSE or STOP key.
2
Use the up and down cursor keys to select SELECT.
3
Turn the rotary knob to select the number of the program (1 to 16) that
you want to execute.
The program name is displayed next to TITLE.
p. 86
If the PBZ is currently in CV mode, select programs that were edited for CV mode. If
the PBZ is currently in CC mode, select programs that were edited for CC mode.
4
Use the up and down cursor keys to select TRIG.RUN.
5
Turn the rotary knob to select ON or OFF.
If you select ON, execution will begin when a TRIG IN signal is applied. If you select
OFF, execution will begin immediately.
p. 89
If you have used to set OPERATION (synchronous operation) to SYNC
SLAVE or SYNC SLAVE END, you cannot specify this setting. Instead of ON or OFF, “-
--” is displayed.
6
Press RUN/PAUSE to start program execution.
The selected program begins executing. The RUN/PAUSE key is illuminated during
execution.
PROG: The number of the program that is executing
(from 1 to 16).
LOOP: The program’s current loop number.
If this number exceeds 10000, “#####” is displayed.
STEP: The step number that is being executed (1 to
1024).
Time elapsed since the step began executing (hours :
minutes : seconds).
When the program finishes executing, the program
completed screen (COMPLETED) appears. The RUN/PAUSE key turns off, and the
STOP key illuminates.
See
• When you are editing programs, you can select which program to edit independent of the
CV/CC mode setting. If you execute a program that was edited for a mode (CV/CC mode)
that does not match the current mode (CV/CC mode) of the PBZ, an error will be
generated.
See
CONFIG