Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 176 / 218

9-6
PAT-T 4kW
Output signals
PAT20-200T PAT40-100T PAT60-67T PAT160-25T
Monitor signal o u tp u t
*1
*1. J1 and J2 connectors on the rear panel.
VMO N (Voltage)
At rated voltage
o
u tp u t
10.00 V ± 0.25 V
At 0 V o u tp u t 0.00 V ± 0.25 V
I MO N (C u rrent)
At rated c u rrent o u tp u t
three-phase
inp u t mode
10.00 V ± 0.25 V
single-phase
inp u t mode
7.50 V ± 0.25 V
The u pper limit is set at 75 % of the rating of the three-phase inp u t mode
At 0 A o u tp u t 0.00 V ± 0.25 V
Stat u s signal o u tp u t
*1, *2
*2. Photoco u pler open collector o u tp u t, maxim u m voltage 30 V, maxim u m c u rrent (sink) 8 mA, ins u lated from the
o u tp u t and control circ u its, and stat u s signals are not m u t u ally ins u lated.
OUTO N STATUS T u rns on w hen the o u tp u t is on.
CV STATUS T u rns on d u ring CV operation.
CC STATUS T u rns on d u ring CC operation.
ALM STATUS T u rns on w hen an alarm (OVP, OCP, OHP, BOHP, PHASE, FA N ,
SE N SE, or SD) is detected.
PWR OFF STATUS
*3
*3. If the breaker is set to trip, the ALARM LED ill u minates for approximately 10 s to 15 s w hen the SD signal is
applied w hile the OVP/OCP is activated.
Stays on for approximately 10 s to 15 s after the POWER s w itch t u rns off.
PWR O N STATUS T u rns on w hen the POWER s w itch is on.