Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 110 / 218

7-4
PAT-T 4KW
7.4 Interface Setup
7.4.1 RS232C Control (Standard Equipped)
RS232C connection
The RS232C port on the PAT is a standard D-sub 9-pin male connector.
Check that the POWER switches of the PAT and computer are off, and connect the
PAT to the computer using a standard cross cable (null modem cable).
Use a D-sub 9-pin female-to-female AT type for the cross cable. Fig.7-1 shows the
connector pin arrangement.
The PAT does not use hardware handshaking (as shown in the cross cable example
2).
Fig.7-1 9-pin AT type connector
RS232C configuration
p. 4-16,
p. 4-22
1
If an option board is installed, select RS232C in the CO N FIG settings
(CF54: 232C).
2
In the CO N FIG settings, set the RS232C data rate (CF40), RS232C
data length (CF41), RS232C stop bit (CF42), and RS232C flo w control
(CF43).
For the settings, see Table 7-1.
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
D-su b 9-pin female D-su b 9-pin female
W iring configuration of the cross ca b le
: Communication line used of this product
#4-40UNC
Inch screw
#4-40UNC
Inch screw
1: CD (carrier detect)
2: RXD (recei v e data)
3: TXD (transmit data)
4: DTR (data terminal ready)
5: GND (signal ground)
6: DSR (data set ready)
7: RTS (re q uest to send)
8: CTS (clear to send)
9: RI (ring indicator)
Facing the PAT rear panel
*
*
*
*
*
*
See