Kikusui PAN 110-1.5A, Руководство по эксплуатации

Страница: 28 / 160

1-10 PAN-A
MODEL 175W/1000W
The input fuses of the models 175W and 1000W are located inside,
and users are not able to check or replace them.
• Users are requested to never remove the cover and
check or replace the fuse.
1.5 Connecting the AC power code
Connect the AC power code to an AC power source speci fi ed for the
unit. A seal is attached to the rear panel indicating the rated input. See
Fig.1-9.
This product is an equipment of IEC Overvoltage Category II
(energy-consuming equipment supplied from the
fi xed installation).
• Do not use the AC power code provided with the product as a
AC power code for other instruments.
MODEL 175W/350W
• In an emergency, the AC power cord with a plug may be used
to disconnect the product from the AC line in an emergency.
Connect the plug to an easily accessible outlet so that the plug
can be removed from the outlet at any time. Be sure to allow
enough space around the outlet.
MODEL 700W/1000W
• In an emergency, the POWER switch of the models 175W
and 1000W may be used to disconnect the product from the
AC line in an emergency. Be sure to allow enough space
around the outlet so that the POWER switch can be turned off
at any time.
Connecting procedure of PAN-A series side
MODEL 175W/350W
1. Insert the supplied AC power code into the AC IN connec-
tor on the rear panel.
WARNING
NOTE