Kikusui PAD-L III Series, Руководство по эксплуатации

Страница: 20 / 132

1-4 Setup PAD-L
Precautions for installation (continued)
Do not place any object on the power supply.
Particularly a heavy one, as doing so could result in a malfunction.
Do not place the power supply on a tilted surface or in a
location subject to vibrations.
If placed on a non-level surface or in a location subject to vibration, the power supply
may fall, resulting in damage and injury.
Do not use the power supply in locations affected by strong
magnetic or electric fields.
Operation in a location subject to magnetic or electric fields may cause the power
supply to malfunction, resulting in electrical shock or fire.
Do not use the power supply in locations where highly-
sensitive measuring instruments or receivers are nearby.
Such instruments may be affected by the noise generated by the unit.
To secure the power supply at an installation site
The PAD-L power supplies are provided with casters for easy mobility. To avoid
unintended movement while the unit is in use, use the stoppers (caster locks and/or
stopper bolts) to secure it to a particular location. The method of securing it in
position differs from TYPE models. See Fig. 1-1.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
NOTE
• To avoid possible damage to the floor when locking the power supply to a
particular location with the stopper bolts, place a rubber sheet or similar
material between the stopper bolt and the floor.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Locking the TYPE III models
Two stopper bolts are provided on the front panel side of the bottom face. Lock the
power supply by adjusting the stopper bolts so that they just touch the floor. The
casters have no locking mechanism.
Locking the TYPE IV models
The casters on the front panel side of the bottom face are provided with a locking
mechanism. Tilt the caster lever to the ON position to lock that caster.