2-18 Installation and Preparation for Use
OT01-PCR-LA/2
Fig. 2-14
Installing a Card in the Slot in a PCR-LA Power Supply
1.
Remove the screws
fi
xing the SLOT3 cover to remove the cover. (Keep
the removed cover to ensure that it is not lost.)
2.
Hold each card so that the part-mounted side of the printed board is at
the right, and insert the board into the slot grooves.
3.
Insert the card into the slots carefully so that the board does not come
out of the grooves. After inserting the card as far as it will go,
fi
x the
card to the PCR-LA power supply using the screws supplied with the
driver.
4.
This completes installation of a card in the slot.
■
Connecting the drive-signal cables
5.
Connect the master-unit card to a slave-unit card using a drive-signal
cable (26 poles).
6.
Open the tabs of the J1 connectors of each card, orient the connector
of a drive-signal cable to a J1 connector, and insert it into the J1 con-
nector. The J1 connector has two connection ports, each of which oper-
ates the same way.
7.
Close the tabs of the J1 connectors to lock the cable connectors.
This completes the connection of a drive-signal cable.
• Do not move a PCR-LA power supply with a drive-signal cable(s) con-
nected to the card. Otherwise, excessive force will be exerted on the cable
and connector, which could result in breakage of the card.
• Before moving the PCR-LA power supply, be sure to disconnect the drive-
signal cable(s).
CAUTION
Содержание OT01-PCR12000LA/2
