Kikusui KHA3000, Руководство по эксплуатации, Страница: 322 / 392

322
KHA3000
Test Execution (Trigger Function)
Sequence 3 (TEST)
INIT:SEQ3
INIT:NAME TEST
Starts testing when IEC 61000-3-3 (ManualSW) is selected in the limit value standard for the
voltage fluctuation measurement mode (VFLuctuation:STANdard:LIMitation).
Command
INITiate[:IMMediate]:SEQuence3
INITiate[:IMMediate]:NAME {TEST}
Parameter Value: TEST
TRIG:SEQ3
TRIG:TEST
Executes a software trigger during test operation.
Command
TRIGger:SEQuence3[:IMMediate][<character>]
TRIGger:TEST[:IMMediate][<character>]
Parameter Value: NEXT (default)
RETRy
TRIG:SEQ3:SOUR
TRIG:TEST:SOUR
Each sets the conditions for actually starting measurement for test operation after reception
of the INIT:SEQ3 command.
When IEC 61000-3-3 (ManualSW) is selected in the limit value standard for the voltage
fluctuation measurement mode (VFLuctuation:STANDard:LIMitation), the second and
subsequent tests always wait for a device trigger. To start the second or a subsequent test,
use a software trigger (*TRG, IEEE 488.1 GET) regardless of the setting of
TRIG:SEQ3:SOUR (TRIG:TEST:SOUR). When the last measurement cycle is completed, it
will not wait for a device trigger.
Command
TRIGger:SEQuence3:SOURce {BUS|IMMediate}
TRIGger:SEQuence3:SOURce?
TRIGger:TEST:SOURce {BUS|IMMediate}
TRIGger:TEST:SOURce?
Parameter Value: BUS Start measurement after waiting for a software trigger
(*TRG, IEEE488.1 GET (Group ExecuteTrigger)).
IMMediate Start measurement immediately (default)
Response
Returns the current setting of the trigger source in the <character> format.
** RST RST
** RST RST