Kikusui KHA3000, Руководство по эксплуатации, Страница: 119 / 392

5
KHA3000
119
Controlling the AC Power Supply
Setting the Harm
onic Test
Voltage and Frequency Settings and ON Phase
No. Menu item Description Default
1 OUTPUT Turn on or off the output of the AC power. In the ON state, the icon in the
upper part of the screen lights up. OFF
2 Voltage Setting Enter the output voltage of the AC power. The input range is 0.0 V to
304.8 V.
Specify the voltage according to the rated voltage of the EUT. This value
determines the voltage range that will be decided in the F4 menu item.
The type of the set value of the output voltage depends on the wiring
method. If the wiring method is single-phase two-wire, single-phase
three-wire, or three-phase four-wire, the phase voltage is used. In the
case of three-phase three-wire, the line voltage is used. (The menus for
setting the wiring method are described in the chapters of harmonic
test, voltage fluctuation test and other tests.)
Enter the value with the numeric keypad and press the ENTER key, or
use the large knob to increase or decrease the value. –
3 Freq Setting Select the output frequency of the AC power according to the rated
frequency of the EUT. 50 Hz
4 Voltage Range Select the output voltage range of the AC power.
Select the 100 V range for an output voltage setting range of 0 V to
152.5 V.
Select the 200 V range for an output voltage setting range of 0 V to
304.8 V. 100 V
5 ON Phase The voltage phase angle when the output of the AC power is turned on
can be specified. In this menu item, select a specification method.
When
“ Free ” is selected, the voltage phase is not specified. When
“ Specified ” is selected, enter a value in the F2 menu item, Phase Angle.
Free
6 Phase Angle Enter a value of the phase angle when “ Specified ” is selected in the F1
menu item. The input range is 0° to 360°.
Enter the value with the numeric keypad and press the ENTER key, or
use the large knob to increase or decrease the value.
0
7 Return Terminates the ON phase selection. –
8 Return Terminates the control of the ON phase. –
9 Alarm Clear Clears the alarm of the AC power. –
10 AC Pow Source Model Select Don’t use or Use . Don ’ t use
F key: Function key. You can also use the ESC key to return.
F1
AC Power Supply Cont
Sub Menu
F1 OUTPUT
OFF
ON
F2
Voltage Setting
(Input numeric value)
F3
Freq Setting
50 Hz
60 Hz
F4
Voltage Range
100 V
200 V
F5
F1
On Phase
Free
Specified
F2
Phase Angle
(Input numeric value)
F6
Return
F6
Return
F3
Alarm Clear
F4
AC Pow Source Model
Don’t use
Use
On Phase Select
Æ
Sub Menu
1
3
2
4
5
6
7
8
9
10
Menu 1/1